Membership in the local Administrators group, or equivalent, is the minimum required to complete this procedure.

To set the accounting scope

  1. Open Windows System Resource Manager. To open Windows System Resource Manager, click Start, point to Administrative Tools, and then click Windows System Resource Manager.

  2. In the Connect to Computer dialog box, select This computer, and then click Connect.

  3. In the console tree, right-click Accounting, and then click Filter View.

  4. In the Configure Accounting View Filter dialog box, click Scope Filter.

  5. In the Scope Filter dialog box, select the Start date check box, and then select a beginning date for your accounting data.

  6. Select the End date check box, and then select an ending date for your accounting data. If you do not select End date, all data from the start date until the current time will be displayed.

  7. Click OK.

Additional considerations

  • In the Configure Accounting View Filter dialog box, you can click Save View to save the current accounting view configuration for later use. Then, you can use Load View to load a previously saved configuration, or Reset View to reset the configuration to the default.

Additional references

Table Of Contents